hp microserver gen8 boot from internal usb

With the SSD through USB you might miss out on a bit of performance, but if that was your biggest concern, you wouldn’t be running an older Microserver in the first place - the ODD SATA slot isn’t a full speed one, either. Just need the SSD (otherwise, as you noticed, you can’t set it as boot), but the rest of the drives that are not set up in the RAID controller get passed through to the OS, and you can use them just fine there. Just for completeness’ sake (not something you’d likely want to change now that everything is running, but maybe for future reference): you don’t need to add the “data” drives in their individual raids. Try a different installer medium to copy the iso over to. So in short, double check your download via downloads page instructinos. I assume that the proposed system drive (the 55.9G drive) is relatively healthy. And if you install USB disk is duff that too could break Are you still around and if so have you now moved to our v4 offering? Not sure if they are yet running the v4 “Built on openSUSE” variant yet thought.Īlso you should make sure your download file is good via the checksum instructions on the downloads page. There are other Gen8 users on the forum I believe so maybe they can chip in with other suggestions. those little squares in the first two lines!! There is a small chance this is down to a ram issue. after setting the root password etc:Īlso you screen grab looks a little strange with some character distortion, i.e.

So is that directly after the progress bar and before a reboot? Or are you getting dropped to the emergency mode only after rebooting when the install has finished. … then it runs through the Loading, then I end up in the Emergency Mode.

Hp microserver gen8 boot from internal usb